Справочник Пользователя для Gateway E-824R
Chapter 2: Installing and Setting Up your Autoloader
www.gateway.com
10
Overview
Preparation
1
Prepare to install your new E-824R or E-826R (see
2
Identifying the correct SCSI bus types (see
Installation
1
Install the autoloader in a computer rack. (see
2
Connect the autoloader to the server. (see
3
Set the SCSI ID for the autoloader (see
4
Turn on the autoloader on to make sure that it passes the Power-on Self
Test (POST).
Test (POST).
Caution
Whenever you power cycle the
autoloader, allow 10 seconds before
turning the power back on. The power
supply requires at least two to three
seconds for the capacitors to discharge.
This ensures a complete system reset on
power down and may avoid system
errors.
Setup and configuration
Set up the host and make sure that the connection is correct (see
).
Preparation
Before you install your new Gateway autoloader, unpack it carefully and inspect
it for any damage that might have occurred during shipping.
it for any damage that might have occurred during shipping.
Make sure that the work area is free from conditions that could cause
electrostatic discharge (ESD). Discharge static electricity from your body by
touching a known grounded surface, such as your computer's metal chassis.
electrostatic discharge (ESD). Discharge static electricity from your body by
touching a known grounded surface, such as your computer's metal chassis.
SCSI bus requirements
You must connect the autoloader to one of the following SCSI bus types:
Important
The autoloader is not compatible with a
High-voltage Differential (HVD) SCSI bus.
■
Ultra 160 SCSI-3, LVD/MSE SCSI bus
■
Ultra 320 SCSI-3, LVD/MSE SCSI bus
Important
The maximum number of autoloaders
supported per SCSI bus is two.
Your SCSI host adaptor card must also support the SCSI bus type used to
connect the autoloader.
connect the autoloader.