Справочник Пользователя для Fluke 2640A

Instrument Preparation

2

2-17

Front Panel Controls

2-21.

Use the front panel controls (Figure 2-8) to enter configuration parameters, and
choose monitoring functions. Table 2-1 summarizes the front panel control
functions.

ENTER Selection

Set/Review

COMMunication

Parameters

Display Digital I/O and Totalizer Status

Display MONitor Channel

COMM

Communication - Set up communication parameters. To review, just
press COMM; to set, press and hold COMM for 3 seconds until the
SET annunciator lights. If you press COMM again during
configuration operations, the operation cancels. The COMM
parameters are as follows:

Base Channel Number (01 to 99)
Line Frequency (50 or 60 Hz)
Ethernet Address (Read Only)
RS-232 (Baud Rate)
Network

Isolated Network
General Network

Internet Protocol (IP) Address
Socket Port
Subnet Mask

Default Gateway Address

DIO

Digital I/O - Display Digital I/O Status and Totalizer count. After
pressing DIO, use the left/right arrow keys to display the DIO status
and the up/down arrow keys to display the totalizer status.

MON

Monitor - Display Monitor Channel. After pressing MON, use the
up/down arrow keys to select the desired channel to monitor.

ENTER

Enter - Make Configuration Selection or Terminate Parameter Entry.

Left/Right Arrows

Used to make selections in setup menus. The arrow keys have an
automatic repeat action when held down for more than 1 second.

Up/Down Arrows

Used to make selections in setup menus and select monitor
channels. The arrow keys have an automatic repeat action.