Справочник Пользователя для Nortel Networks AN/DC
Installing and Operating AN/DC and ANH-8/DC Systems
3-12
312410-A Rev 00
Continuing with Directed Netboot
Before you can use the Directed Netboot procedure, you must have already used
the
the
ifconfig
command (as described in the previous section) to configure the
interface from which you plan to use Directed Netboot.
You can use the Diagnostic Monitor, Technician Interface, or Site Manager to
perform Directed Netboot. This guide assumes that you are at the router site and
are using the Diagnostic Monitor. To manage the router from a remote site, refer
to Connecting BayStack AN and ANH Systems to a Network.
perform Directed Netboot. This guide assumes that you are at the router site and
are using the Diagnostic Monitor. To manage the router from a remote site, refer
to Connecting BayStack AN and ANH Systems to a Network.
To use the Directed Netboot feature:
1.
Contact your network administrator to verify that the remote network is
set up for the Directed Netboot procedure.
set up for the Directed Netboot procedure.
2.
Ask your network administrator (or refer to Appendix A) for the
appropriate boot configuration (
appropriate boot configuration (
bconfig
) commands.
Write the commands below for reference.
bconfig image ________________________
bconfig config ________________________
3.
At the Diagnostic Monitor prompt, enter the appropriate
bconfig
commands.
You must enter one
bconfig
command to specify the location of the software
image, and another to specify the location of the configuration file.
shows sample commands.
Figure 3-9.
Specifying the Source for Directed Netboot
AN_DIAG>>
bconfig image network 192.32.x.x /usr/anstartup/krnl_an.exe
Done.
AN_DIAG>>
AN_DIAG>>
bconfig config network 192.32.x.x /usr/anstartup/config
Done.
AN_DIAG
AN_DIAG
AN0019A