Справочник Пользователя для Fellowes 320 320C

Paper shredder

Edition 01/03

7

Red LED lights

– Paper shredder switches off automatically.

• Press rocker switch to center position (2).

• Make sure cabinet door is properly

closed and/or exchange cut material
bag.

• Return switch to "on" position (1) and

continue shredding

(Cross cut unit only)

– When shredding capacity drops or the

noise increases.
• Apply oil over full width of cutting

cylinders through the paper entry
(Fellowes Powershred Lubricant
# 35250).
CAUTION: Do not use flammable
synthetic oil, petroleum-based
products, or aerosol lubricants of any
kind.

• Run cutting system forward and back-

ward several times without feeding
paper.

• Continue shredding.

If  the equipment does not work properly, please
check the following points first:

–

Is the plug inserted?

–

Is the switch turned on?

–

Is the cabinet door closed?

–

Is waste receptacle full?
Empty waste bag.

–

Is there a paper jam in the shredder?

–

Is the motor overheated?
Switch machine off and allow motor to
cool down for approximately 15–20 min.

If none of the above applies and the equipment still
does not run, please contact our customer service
department.

• Press rocker switch to center position (2)

to stop the cutting system

• Press and hold down rocker switch in

pos. 3 to reverse the cutting system and
back out jammed material
(paper is pushed out)

Caution!

Do not 

attempt to force the jammed

material through the machine by
alternating the cutting system between
forward and reverse

• Remove excess paper

• Return switch to pos. 1 and continue

shredding in smaller quantities so as not
to jam the machine further

Note:

The 320-2HS 

will not run 

forward again

unless the jammed material has been
completely removed from the throat