Справочник Пользователя для Troy-Bilt J609

19

To remove the cutting deck, proceed as follows:
•

Place the PTO (Blade Engage) lever in the 
disengaged (OFF) position and engage the parking 
brake.

•

Lower the deck by moving the deck lift lever into the 
bottom notch on the right fender.

•

Remove the deck belt from around the tractor’s 
engine pulley and idler pulleys (Refer to Changing 
the Deck Belt).

•

Looking at the cutting deck from the left side of the 
tractor, locate the deck support pin on the rear left 
side of the deck. See Figure 15.

•

Rotate the pin slightly toward the rear of the tractor 
and release the pin into the hole provided.

•

Pull the deck support pin outward to release the 
deck from the deck lift arm.

•

Repeat the above steps on the tractor’s right side.

•

Move the deck lift lever into the top notch on the 
right fender to raise the deck lift arms up and out of 
the way.

•

Gently slide the cutting deck toward the front of the 
tractor allowing the hooks on the deck to release 
themselves from the deck stabilizer rod.

•

Gently slide the cutting deck (from the right side) 
out from underneath the tractor.

Never exceed the maximum

inflation pressure shown on the sidewall of the
tire.

The recommended operating tire pressure is:

•

Approximately 10 psi for the rear tires 

•

Approximately 14 psi for the front tires

 Refer to the tire sidewall for exact tire 

manufacturer’s recommended or maximum psi. Do not 
overinflate. Uneven tire pressure could cause the 
cutting deck to mow unevenly.

The battery is sealed and is maintenance-free. Acid 
levels cannot be checked.

•

Always keep the battery cables and terminals clean 
and free of corrosive build-up.

•

After cleaning the battery and terminals, apply a 
light coat of petroleum jelly or grease to both 
terminals.

•

Always keep the rubber boot positioned over the 
positive terminal to prevent shorting.

 If removing the battery for any reason, 

disconnect the NEGATIVE (Black) wire from it’s 
terminal first, followed by the POSITIVE (Red) wire. 
When re-installing the battery, always connect the 
POSITIVE (Red) wire its terminal first, followed by the 
NEGATIVE (Black) wire. Be certain that the wires are 
connected to the correct terminals; reversing them 
could change the polarity and result in damage to your 
engine’s alternating system.

If the tractor has not been put into use for an extended 
period of time, charge the battery with an automotive-
type 12-volt charger for a minimum of one hour at six 
amps.

Batteries give off an explosive

gas while charging. Charge battery in a well
ventilated area and keep away from an open
flame or pilot light as on a water heater, space
heater, furnace, clothes dryer or other gas
appliances.

When removing or installing

the battery, follow these instructions to
prevent the screwdriver from shorting against
the frame.

 Never jump your tractor’s dead battery 

with the battery of a running vehicle.

•

Connect end of one jumper cable to the positive 
terminal of the good battery, then the other end to 
the positive terminal of the dead battery.

•

Connect the other jumper cable to the negative 
terminal of the good battery, then to the frame of 
the unit with the dead battery.

Support Pin