Справочник Пользователя для McCulloch 532 43 21-09

The carburetor has been preset at the factory and ad just ment 

should not be necessary.  However, engine per for mance 

can be affected by dif fer enc es in fuel, tem per a ture, al ti tude 

or load.  If the carburetor does need ad just ment, contact 

your nearest authorized service center/de part ment

IMPORTANT:  NEVER TAMPER WITH THE ENGINE GOVERNOR, 

WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.  

OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH 

SPEED SETTING CAN BE DANGEROUS.  IF YOU THINK THE 

ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, 

CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/

DEPARTMENT, WHICH HAS THE PROPER EQUIP MENT AND 

EXPERIENCE TO MAKE ANY NEC ES SARY ADJUSTMENTS.

•  Remove screws from side of belt guard.

•  Pull belt guard out and away from unit.

• 

Replace belt guard by re vers ing above procedure.  Be 

sure slot in bot tom of belt guard is under head of tine 

shield bolt and all nuts are tight ened se cure ly.

Replace V-belt if it has stretched con sid er ably or if it has cracks 

or frayed edges.  

•  Belt guard must be removed to ser vice belt.  See “TO 

REMOVE BELT GUARD”  in this section of manual.

LT REMOVAL

• 

Remove V-belt from trans mis sion pul ley first and then 

from engine pul ley.

BELT REPLACEMENT 

• 

Install new V-belt to engine pul ley first then to trans mis-

 sion pulley.  Be sure belt is po si tioned on inside groove 

of both pulleys, inside all belt guides and rests on idler 

pulley.CHECK TINE OPERATION

•  See “TINE OPERATION CHECK” in this section of 

man u al.

•  Replace belt guard.

FINAL CHECK “ON” POSITION
• 

With tine control “ON” (held down to handle) push down 

on handle to raise tines off the ground.

•  Slowly pull recoil starter handle while observing tines.  

Tines should rotate forward.

•  If tines do not rotate, inner wire of control cable is too 

loose.  Loosen cable clip and pull cable up to remove 

slack and retighten clip.

•  Recheck in “ON” position and adjust  if necessary.

NOTE:  If “ON” position check required adjustment, re check 

“OFF” position adjustment to insure tines do not rotate when 

control is “OFF” (up).