Справочник Пользователя для Regency L676-NG1

Regency

®

 L676-1 Direct Vent Gas Fireplace

INST

ALLA

TION

Vent restriction is required for certain venting 
installations, see the diagrams in the "Venting
Arrangements" section to determine if they are 
required for your installation.

The Vent Restrictor plate is located on the inside 
top of the fi rebox.

Screws for plugging the holes.
(all holes must be plugged with a screw).

Screw holes for fi xing the restrictor plate.

To set the vent restriction as indicated in the 
venting arrangements diagrams, refer to the 
following instructions;

3)  Remove the glass door.

 

a.  Release the 2 door latches on the left      
     and right side at the top of the fi rebox.

 b.  Swing the door out from the top and release   

the hinge on the left side of the  door and 
lift out.

6)     Once the vent restrictor plate is in the required 

position, secure with screws.

1)  Remove the right side mesh by gathering the 

mesh together and lifting the curved end of 
the rod up and out of the bracket located on 
the top right of the glass frame.

 

Now slide the straight end of the rod out from 
the bracket located on the middle inside top 
of the outer shell. Repeat for left side.

2)  Remove the front cover plate by lifting up 

off of the pins on the left and right side of 
the fi rebox.

Vent Restrictor Set 4

    

Position the baffl e plate on the top inside 
wall of the fi rebox, push it back until it  

    contacts the back wall of the fi rebox. 
    Center it between the 2 relief doors (see 

above diagram), secure with 2 self tapping 
screws provided.

7) Vent Restrictor Set 4 = combination of 
    Vent Restrictor Set 1 + installation of  the    

baffl e plate (see below).

4)  Remove the screws that hold the vent 

restrictor plate in place.

5)   Adjust the vent restrictor plate to the required 

vent restrictor position as per the diagrams 
shown.