Справочник Пользователя для Vermont Casting 2467

11

The appliance must only use the gas specified on the 
rating plate, unless converted using a CFM Corporation 
Fuel Conversion Kit. Refer to Page 23 for the correct 
Fuel Conversion Kit for your model.

Conversion instructions are provided with each kit and 
beginning on Page 16 in this manual.

In order to connect Natural Gas, use a fitting with 
3/8” NPT nipple on the valve side and 1/2” natural gas 
supply line with an input of 28,000 BTUs at a manifold 
pressure of 3.5” and a minimum inlet supply pressure of 
5.5” w.c.

In order to connect Propane, use a fitting with 3/8” 
NPT nipple on the valve side and 1/2” propane gas 
supply line with an input of 26,000 BTUs at a manifold 
pressure of 10.0” and a minimum inlet supply pressure 
of 11.0” w.c. 

The switch assembly parts are found in the parts bag.
1.  Attach switch assembly to left rear side of stove 

shroud (when facing shroud) using two screws and 
existing holes in shroud. (Fig. 19)

2.  Run wires down back of stove, under bottom of rear 

shroud to valve.

3.  Attach wires to valve terminals. (Fig. 20)

ST315

attach switch assy

1/31/00   djt

Switch As-

sembly

Screws

Existing 

Holes

ST315

Fig. 19   Attach switch assembly to rear shroud.

PILO

T

ADJ

TP

TH

TPTH

ST228

attach switch

wires to valve

12/99

ST228

Fig. 20  Attach switch wires to valve.

1.  Remove the logs from their packaging, and inspect 

each piece for damage. DO NOT INSTALL DAM-
AGED LOGS.

2.  Install the rear log centering it side to side on the 

sheet metal shelf at the back of the firebox. (Fig. 21) 
The log will touch both sides and the back wall of the 
firebox.

3.  Install the right log by engaging hole on bottom with 

pin on the rear log. (Fig. 21) Then set right bottom 
side on the burner so the edge of the log touches 
the right side of the firebox. The right log does not 
use the locator pins on the burner to stay in place.

4.  Install the left log by engaging hole on bottom with 

pin on rear log. (Fig. 21) Then set left bottom side 
on the burner so the edge of the log touches the left 
side of the firebox.

5.  Loosely sprinkle the lava rocks directly on top of the 

burner in front of and between the decorative grate 
and the right and left logs. Use the lava rock to cover 
brackets on the burner. (Fig. 22)

 

 

18 

40 feet

 

20 

25 feet

 

22 

16 feet

Check the table below for the appropriate gauge ther-
mostat wire to use for the length of lead required in your 
installation.

1.  Install the wall thermostat in the desired location and 

run the wires to the stove location. Terminate these 
leads with 1/4” female connectors.

2.  Connect the thermostat wires to the valve.  (Fig. 20)