Справочник Пользователя для Hitachi VM-3700A

VIEWING THE PICTURE PLAYED BACK ON YOUR TV 

 

61

NOTE: When noise appears in the played back picture, adjust "TRACKING" control on the 
VCR so there is no noise. 

Diagram of Hookup 

1. Disconnect the VHF antenna leads from the rear of the TV receiver. 

NOTE: Leave the UHF antenna leads connected to the TV. 

2. Connect the VHF antenna lead to "IN FROM ANT" on the RF converter unit. If the 
cable is round (75 Ohm), it will connect directly to the "IN FROM ANT". If it is the flat 
type, (300 Ohm), connect it to the antenna adaptor (300 Ohm to 75 Ohm) and slip the 
adaptor on to the "IN FROM ANT" terminal. 
3. Connect the 75 Ohm coaxial cable with antenna adaptor to "OUT TO TV" on the RF 
converter unit. 
4. Connect the other end to the VHF antenna terminal on the TV, as illustrated. 
5. Connect the connector cable from RF converter unit to "RF DC OUT", "AUDIO", and 
"VIDEO" jacks on the camcorder. 
6. Turn on the TV and set to channel 3 unless channel 3 is one of the TV stations in 
your area. If channel 3 is used in your area, set your TV to channel 4. 
7. Set the RF channel selector on the RF converter unit to "CH3" or CH4" to match the 
channel selector on your TV. 
8. Perform same procedures in steps 4 through 8 of "Example 1". 

NOTE: If you want to watch a TV program with camera/recorder connected as illustrated, 
slide "POWER" switch of the camera/recorder to "OFF".