Справочник Пользователя для Kodak 1942390

Скачать
Страница из 70
Appendix
www.kodak.com/go/support
 55
claims of your customers for such damages resulting from the purchase, use, or failure 
of the Product), regardless of cause or for breach of any written or implied warranty is 
expressly disclaimed. The limitations and exclusions of liability set forth herein apply 
to both Kodak and its suppliers.
Your rights
Some states or jurisdictions do not allow exclusion or limitation of incidental or 
consequential damages, so the above limitation or exclusion may not apply to you. 
Some states or jurisdictions do not allow limitations on how long an implied warranty 
lasts, so the above limitation may not apply to you. This warranty gives you specific 
rights, and you may have other rights which vary from state to state or by jurisdiction.
Outside the United States and Canada 
In countries other than the United States and Canada, the terms and conditions of 
this warranty may be different. Unless a specific Kodak warranty is communicated to 
the purchaser in writing by a Kodak company, no warranty or liability exists beyond 
any minimum requirements imposed by law, even though defect, damage, or loss may 
be by negligence or other act.
Regulatory compliance
FCC compliance and advisory
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy 
and, if not installed or used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 1) reorient or relocate the 
receiving antenna; 2) increase the separation between the equipment and the