Справочник Пользователя для Mitsubishi Electronics QnUCPU
1
-
2
1.2 Storing and Executing Programs
This section describes where to store and how to execute the programs in the CPU module.
(1) Programming
Programs are created with GX Developer.
For details of program configuration and execution conditions, refer to CHAPTER 2.
For details of program configuration and execution conditions, refer to CHAPTER 2.
(2) Storing programs
Created programs and set parameters are stored in the following memories of the CPU module.
(
• Program memory
• Standard ROM (parameters only)
• Memory card
• Standard ROM (parameters only)
• Memory card
(3) Executing programs
The CPU module executes the programs stored in the program memory.
To execute the programs stored in a memory card, the programs need to be booted to the program memory
(
Section 5.1.8) when the CPU module is powered off and then on or reset.
Figure 1.2 Executing programs
Figure 1.3 Executing programs stored in a memory card
CPU module
The CPU module executes
the programs stored here.
the programs stored here.
Program memory
Parameter
Program
Device comment
Initial device value
Comments are stored
separately from the program.
separately from the program.
The CPU module executes the programs
booted from a memory card to here.
booted from a memory card to here.
Program
memory
memory
Device
comment
comment
Parameter
Program
Initial device
value
value
CPU module
Boot
Memory card