Справочник Пользователя для Mitsubishi Electronics QnUCPU

11

 

-

 

5

CHAPTER11 PROCEDURES FOR WRITING PROGRAM TO CPU MODULE

11.
3 

 P

roce
dure f

o

r 

W

rit

ing O

ne 
Pr

ogram

  

11.3  Procedure for Writing One Program

This section describes a procedure for writing a program to the program memory. (

Follow the procedure below and then the procedure provided in Section 11.5 before storing the program in 
the memory card for boot operation.

In the following procedure, 

 indicates an operation on the CPU module side.

YES

NO

1)

Section 6.25

Section 6.25

Section 6.25

Use the initial device value?

Set the device memory.

Set the initial device value range.

Set a file name for initial device value in the 
PLC file tab of the PLC parameter dialog box.

Set the RUN/STOP/RESET switch to STOP 
and power on the CPU module  
(the ERR. LED turns on).

NO

YES

Start

Start GX Developer.

Set the project.

Change the number  

of device points?

Change the number of device points in the  
Device tab of the PLC parameter dialog box.

Create a program to be executed in the  
CPU module.

GX Developer Version 8 Operating Manual

GX Developer Version 8 Operating Manual

Ladder (writing) screen