Справочник Пользователя для Mitsubishi Electronics QnUCPU

11

 

-

 

10

11.5  Procedure for Boot Operation

This section describes a procedure for boot operation.

In the following procedure, 

 indicates an operation on the CPU module side.

YES

NO

YES

NO

Section 5.1.8

Section 2.3

Section 5.1.7

Start (continued from  

If the RUN/STOP/RESET switch is in 
RUN, set the switch to STOP.

Set the file name of parameters, a 
program, devices, initial values and 
device comments in the Boot file tab 
of the PLC parameter dialog box.

Set the names and execution conditions of 
programs to be executed in the Program tab 
of the PLC parameter dialog box (This setting 
is necessary when one program is written).

Use the memory 

card (except the 

Flash card)?

Select [Online]     [Format PLC memory] 
in GX Developer and format the 
program memory.

Select [Online]     [Write to PLC (Flash ROM)]
     [Write to PLC (Flash ROM)] "Program 
memory/Device memory" for "Target 
memory" in GX Developer and write the 
parameters and created programs.

Power off the programmable controller 
and then on or reset the CPU module.

Is the BOOT LED on?

End

GX Developer Version 8 Operating Manual