Справочник Пользователя для Mitsubishi Electronics QnUCPU
CHAPTER2 SEQUENCE PROGRAMS
1
2
3
4
5
6
7
8
2.
3
S
e
ttings
W
h
en P
rogram
is
Divided
Divided
2
-
13
2.3 Settings When Program is Divided
When one sequence program is divided into multiple programs, execution conditions, such as executing a
program only once at start-up or executing a program at fixed intervals, can be set for each program.
program only once at start-up or executing a program at fixed intervals, can be set for each program.
(1) Control by multiple programs dividing one program
The CPU module can store multiple programs divided on the basis of each control unit.
This enables programming of one sequence program by two or more designers.
This enables programming of one sequence program by two or more designers.
(2)
Settings required for execution of multiple programs
To execute multiple programs in the CPU module, names (file names) and execution conditions of the
programs must be set.
Set them in the Program tab of the PLC parameter dialog box.
programs must be set.
Set them in the Program tab of the PLC parameter dialog box.
Figure 2.15 Control by multiple programs
Figure 2.16 Program setting
Control data A
Control by one program
Control data B
Control data C
Control data A
Control data B
Control data C
Program A
Program B
Program C
The programs divided on
the basis of each control
data are registered.
the basis of each control
data are registered.
Divide one program
into multiple
programs.
into multiple
programs.
(c)
(a)
(b)
(b) 4)
Programs are executed
according to the setting
order.
according to the setting
order.