Справочник Пользователя для Mitsubishi Electronics QnUCPU
4
-
2
CHAPTER4 ASSIGNMENT OF BASE UNIT AND I/O NUMBER
1
2
3
4
5
6
7
8
4.
1
B
B
a
se Unit
As
signment
signment
4.
1.
2
Bas
Bas
e
unit
as
signment
signment
set
ting
ting
(b) Setting the number of slots smaller than the actual one
Set the smaller number than the actual number of slots when slots with no module mounted need not be
recognized.
For example, four slots from the right end of the base unit will be the prohibited slots when using a 12-slot base
unit and setting the number of available slots to eight. (Mounting a module on a prohibited slot causes
"SP.UNIT LAY ERR.".)
recognized.
For example, four slots from the right end of the base unit will be the prohibited slots when using a 12-slot base
unit and setting the number of available slots to eight. (Mounting a module on a prohibited slot causes
"SP.UNIT LAY ERR.".)
4.1.2 Base unit assignment setting
Set base units on the I/O assignment tab of the PLC parameter dialog box.
(1) Auto/Detail
Select the mode for the base unit assignment either from auto mode or detail mode.
(2) Base model name, Power model name, and Extension cable
Enter the model names of mounted base units, power supply modules, and extension cables to be used within 16
characters for user reference or when printing out parameters.
CPU modules do not use the entered model names.
characters for user reference or when printing out parameters.
CPU modules do not use the entered model names.
Figure 4.2 Setting the number of slots smaller than the actual one
Figure 4.3 I/O assignment setting
CPU
0
1
2
3
4
5
6
7
8
9
10
11
Q312B
Main base unit
Power supply
module
module
CPU module
Number of slots set
Mounting a module will result in an error.
Slot number
Actual number of slots
Prohibited
Prohibited
Prohibited
Prohibited
(2)
(3)
(4)
(1)