Справочник Пользователя для Mitsubishi Electronics LT-2240

Connecting MonitorLink™ or a Computer

MonitorLink Connection

(Figure 14)

1. Connect a MonitorLink/DVI cable from the TV side

panel to the Mitsubishi HD Receiver/Controller back
panel.

2. Connect the MonitorLink Control/RS-232 cable from

the TV side panel to the Mitsubishi HD Receiver/
Controller back panel.

3. Connect the L (left) and R (right) audio cables from

the HDTV receiver to AUDIO LEFT and AUDIO
RIGHT on the MonitorLink section of the TV side
panel.

NOTE: The MonitorLink/DVI and 9-pin
RS-232 cables can be found at your local electronics

store. Please refer to www.mitsubishi-tv.com for more

information on RS-232C control.

CAUTION:

To assure continued FCC compliance,

the user must use a shielded video interface cable

with bonded ferrite cores at each end, when using the
MonitorLink/DVI input

Note: The TV side panel and connections shown here are for reference only and may vary by model.

Connecting a Computer

(Figure 15)
•

Your Mitsubishi TV supports VGA, SVGA, XGA,

and WXGA PC resolutions only. (60Hz only)

1. Connect a Mini D-sub 15-pin (RGB) cable from
the TV side panel to PC or Macintosh® back panel.

2. Connect a PC Audio Cable (or 1/8” stereo

mini jack cable) from the TV side panel to PC or
Macintosh back panel.

NOTE: The Mini D-sub 15-pin (RGB) and 1/8”
(3.5mm) stereo mini jack cables can be found at your
local electronics store.

NOTE: Connecting your computer to this TV

will allow you to display your computer’s images.
Since this monitor is widescreen (16:9 aspect ratio),
the display configuration will vary depending on
which video card or driver(s) you use. You may also
need to use a Macintosh adapter when connecting to
some Macintosh computers.

Figure 15. Connecting Computer

��

�

��

�

��

�

��

�

Figure 14. Connecting MonitorLink

��

�

��

��
��

�

��

�

��

��
��

��

�

��

�

��

�

��

LT2240_LT3040_OG_v6.ind

04.1.21, 4:03 PM