Справочник Пользователя для Mitsubishi Electronics LT-2240

�

��

�

��
��

��

Monitor Tilt/Input Terminal Access/Cable Management

Figure 1. Monitor Tilt

Figure 2. Input Terminal Access

Monitor Tilt

(Figure 1)

You have the ability to adjust the viewing angle and tilt of
this monitor

1. Grab the TV with two hands by placing one hand on

each side of the TV.

2. Using little force, push or pull the monitor towards

you for preferred viewing position. Use caution when

pulling so that the base does not slide.

Input Terminal Access/Cable Management

(Figures 2, 3 and 4)

1. Locate the two input terminal covers located on both

sides of your TV (back panel).

2. Gently push the two push tabs the opposite direction

and push towards the side of the TV to remove the

terminal cover(s).

3. After you neatly route all of the cable downward

through the cable management slots, place the terminal

cover back into place, so the cover can close over them

(Figure 3).

4. Position the four tabs directly opposite the four slots

on the TV (Figure 3) and gently push towards the front

of the TV.

5. Slide the two push tabs into the slots on the other

side of the terminals until both tabs snap into place. Do

not force.

6. Replace the cable management cover (shield) by

lining up the three slots on the back of the television.

The shield will neatly conceal your connection cables.

Figure 4. Cable Management Cover

��
��

��

LT2240_LT3040_OG_v6.ind

04.1.21, 4:06 PM