Справочник Пользователя для Dynex DX-19L200A12

Make sure that the power cord is connected to a 
power outlet.

Press POWER to turn on your TV.

Press POWER again to turn off your TV. Your TV 
enters Standby mode.

Turn on your TV, then press INPUT. The Input Select 
list opens.

Press 

 or 

 to highlight the video input source, 

then press ENTER, or press the number button that 
corresponds to the input you want. 

• Press CH+ or CH– to go to the next or previous 

channel on the memorized channel list.

• Press the number buttons to enter the channel 

number you want, then wait for the channel to 
change or press ENTER to immediately change the 
channel.

• To select a digital sub-channel, press the number 

buttons to select the main digital channel, press 

, 

then press the number button for the sub-channel. 
Wait for the channel to change, or press ENTER to 
immediately change the channel.

• Press RECALL to go to the last viewed channel. Press 

RECALL again to return to the channel you were 
watching.

• Press VOL+ or VOL– to increase or decrease the 

volume.

• Press MUTE to turn off the sound. Press MUTE again 

to turn the sound back on.

To set the TV to turn off after a preset amount of time, 
press SLEEP on the remote control. The clock adds 10 
minutes for each press of the SLEEP button (Off, 0h 10m, 
0h 20m, 0h 30m, 0h 40m, 0h 50m, 1h 0m, 1h 10m, 1h 20m, 
1h 30m, 1h 40m, 1h 50m, 2h 0m). After the sleep time is 
programmed, the display appears briefly every ten 
minutes to remind you that the sleep timer is operating. 
To confirm the sleep timer setting, press SLEEP and the 
remaining time is displayed for a few seconds. To cancel 
the sleep timer, press SLEEP repeatedly until the display 
turns to Off.

• Press INFO to view an information banner. The 

information banner shows the current program 
information such as channel number, video input 
source, and resolution.

• Digital channel information—Displays the 

channel number, station name, channel label, 
broadcast program name, TV rating, signal type, 
audio information, resolution, CC mode, current 
time, and current program start and end times.

• Analog channel information—Displays channel 

number, channel label (if preset), signal type, 
audio information, and resolution.

•

Depending on the signal source selected, you 
may see different options on your screen. The 
following menus are shown in TV mode.

•

Menus in this manual are described in TV mode, 
unless otherwise indicated.

•

The screens shown in this manual are for 
explanation purposes and may vary from the 
actual screens on your TV.

DX-19L200A12_11-0606 MAN_ENG_V1.book  Page 16  Thursday, November 3, 2011  10:06 AM