Справочник Пользователя для Fostex D-160
D-160 Owner's Manual (MIDI sync function)
133
POWER
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/16
7/15
6/14
5/13
4/12
3/11
2/10
1/9
RECORD TRACK
HD ACCESS
LOCKED
MTC IN
END
IN
OUT
START
AUTO PUNCH
AUTO PLAY
IN
OUT
AUTO RTN
CLIPBOARD
PASTE
MOVE
COPY
AUTO RTN
ERASE
UNDO
REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/
STORE
RECALL
TIME BASE SEL
TAKE
REHEARSAL
LOCATE
PUNCH
F FWD
REWIND
PLAY
STOP
RECORD
VARI PITCH
LOCATE ABS END
6. Multitrack system using a D-90 / D-80 (Ver. 2) / DMT-8 (Ver.2/VL)
This section explains a multitrack system that uses the D-160 as master and a D-90, D-80,
D-80Ver. 2, DMT-8 Ver. 2, or DMT-8VL as slave. Using the D-160 as a master device
allows for Chase Lock operation using the Vari-pitch function or the MTC.
The example explained here uses Fostex DMT-8 Ver. 2 as a slave machine, but you can
use another model with the same settings to configure the multitrack system.
D-80Ver. 2, DMT-8 Ver. 2, or DMT-8VL as slave. Using the D-160 as a master device
allows for Chase Lock operation using the Vari-pitch function or the MTC.
The example explained here uses Fostex DMT-8 Ver. 2 as a slave machine, but you can
use another model with the same settings to configure the multitrack system.
<Note>
A DMT-8, which does not have a Slave Sync function, cannot be used in this system.
However, it can be used as a master device. Refer to the “Hint” described later.
However, it can be used as a master device. Refer to the “Hint” described later.
<Note>
Note the following when you use the D-160 along with a D-90, D-80, D-80 Ver. 2, DMT-8 Ver.
2, DMT-8VL, or DMT-8.
2, DMT-8VL, or DMT-8.
1. Use only Programs P1 - P5.
2. Select 44.1kHz for the sampling frequency.
3. Select S/P DIF for the digital signal. An adat digital signal can be used only on the D-90.
2. Select 44.1kHz for the sampling frequency.
3. Select S/P DIF for the digital signal. An adat digital signal can be used only on the D-90.
* Initialize the D-160 and the DMT-8 Ver. 2.
* Check the Programs on both machines (P1-P5).
* Set the sampling frequency on both machines to 44.1kHz.
Connecting the devices
* Connect DATA OUT of the D-160 to DATA IN of the DMT-8 Ver. 2, and MIDI OUT of the
D-160 to MIDI IN of the DMT-8 Ver. 2.
<Note>
The best setup is to supply the MTC and S/P DIF digital signal from the master device so
slave operation will be successful.
slave operation will be successful.
MIDI IN
DATA OUTPUT 1-8
DATA IN
D-160 (Master)
DMT-8 ver.2(Slave)
MIDI OUT