Справочник Пользователя для Panasonic WJ-HD500A

74

2. Select an item or item parameter in the menu by press-

ing the D or C button.

3. To return to the previous setup menu, press the

button.

●

1. Move the cursor to DISK INFORMATION in the DISK

MANAGEMENT menu by pressing the C or  D button,
then press the 

button.

The DISK INFORMATION table appears on the monitor,
as shown below.

2. To return to the previous setup menu, press the

button.

●

This item lets you determine the indication mode for the
FULL indicator when the remaining storage capacity is run-
ning low on the Hard Disk.

1. Move the cursor to the HDD FULL parameter in the

DISK MANAGEMENT menu by pressing the C or  D
button.

2. Select the desired indicator mode by pressing the + or

- button.

No warning for remaining space

The selected warning is issued if the remain-

ing storage capacity is between 1 and 10%.

The factory default setting is 1%.

This setting is applied to the display on the moni-

tor screen and signal output from the CONTROL
port.

4. Select either YES or NO by pressing the + or  - but-

ton.
Select YES, then press the 

button to execute the

selection (save or load).
The display shown below appears on the monitor

5. To return to the previous setup menu, press the

button.

■

The Hard Disk status can be displayed on the monitor
screen.

1. Move the cursor to DISK MANAGEMENT in the SYSTEM

SETUP menu by pressing the C or  D button, then
press the 

button.

The DISK MANAGEMENT menu shown below appears
on the monitor.

¢¢¢

¢¢