Справочник Пользователя для Q-See QS4474

CHAPTER 5  RECORDING

The Mask Field lets you block a specific portion of a channel you do not want recorded or 
shown on the display screen. This can be useful if you need to conceal a sensitive area being 
captured by the installed camera.

The default recording mode for your DVR is “Alarm’ which includes motion detection. The 
Motion Detection menu can be found by accessing the Advance menu from the Main 
Menu. In this menu you can configure motion detection for each channel.
The menu will only display four channels at a time. The pull-down menu in the upper left of the 
menu allows you to switch between available groups of four channels.
The motion detection options for each camera can be selected independently and are 
available below each camera’s channel number.

To use the mask field:

STEP 1. From the Record menu, click 

MASK FIELD SETUP. The Mask 
Field menu opens.

STEP 2. Choose a channel you wish to 

apply the Mask Field. 

STEP 3. Select ON from the SWITCH 

drop-down menu.

STEP 4. Click SETUP. The Mask menu 

will be replaced by the full-screen 
camera view of the desired channel.

STEP 5. Using the mouse, click and drag 

the cursor over the area you want to 
conceal. A single click will produce a 
small black square.

STEP 6. Right-click anywhere on the 

screen to return to the Mask Field 
menu.

STEP 7. Click APPLY. Click CLOSE in 

the confirmation window.

STEP 8. Click EXIT in all menus until all 

windows are closed.

Motion Detection Settings
STATUS Select ON to enable motion detection for the desired channel. 
SENSITIVITY Select 1 through 8. The higher the number, the more sensitive the motion 
detection.
MD SETUP This allows you to chose which areas of the camera’s field of view should detect 
motion.

STEP 1. Click SETUP and a motion 

detection grid appears over the 
selected camera’s video in full screen.

STEP 2. Click the blocks in the grid to 

enable/disable motion detection.

    Red=Motion detection enabled
    Clear=Motion detection disabled.
STEP 3. Right-click anywhere on the 

screen to return to the Motion 
Detection menu.

STEP 4. Click APPLY. Click CLOSE in 

the confirmation window.

STEP 5. Click EXIT in all menus until all 

windows are closed.

The Motion Detection buzzer can be enabled or disabled in the Alarm Setup menu covered in 
Section 6.1 Alarms.
EMAIL An email alarm can be assigned to individual channels. Email notifications are covered 
in Section 6.2 Email.