Справочник Пользователя для Speco Technologies CS16
16-Channel Digital Video Recorder
37
Selecting DHCP from the Type and highlighting Save button
reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.
reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.
Highlight Auto (Default) and press the button to toggle
between On and Off. When it is On, the DVR will obtain the
IP address of the DNS server automatically.
between On and Off. When it is On, the DVR will obtain the
IP address of the DNS server automatically.
NOTE:
Selecting Auto will only be enabled when the DVR
is configured for DHCP or an ADSL network.
Selecting ADSL (with PPPoE) allows you to set up the ADSL
network.
network.
Highlight the box beside ID and press the button. A
virtual keyboard appears allowing you to enter the ID for
ADSL connection.
virtual keyboard appears allowing you to enter the ID for
ADSL connection.
Highlight the box beside Password and press the button.
A virtual keyboard appears allowing you to enter the password
for ADSL connection.
A virtual keyboard appears allowing you to enter the password
for ADSL connection.
NOTE:
Entering the ID and Password and highlighting OK
reads the current IP address of the DVR configured
by the ADSL network.
by the ADSL network.
NOTE: If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR might change whenever
the unit is turned on.
Highlight the DVRNS tab, and the DVRNS screen displays.
Highlight Use DVR Name Service and press the button
to toggle between On and Off.
to toggle between On and Off.
NOTE:
The DVRNS (DVR Name Service) allows the DVR to
use Dynamic IP addresses for remote connection.
When this feature is On, you can access your DVR
remotely using the DVR name instead of its IP
address. For the DVRNS feature, the DVR should
be registered on the DVRNS server.
When this feature is On, you can access your DVR
remotely using the DVR name instead of its IP
address. For the DVRNS feature, the DVR should
be registered on the DVRNS server.
Highlight the box beside DVRNS Server and press the
button. A virtual keyboard appears allowing you to enter the
IP address or domain name of the DVRNS server.
button. A virtual keyboard appears allowing you to enter the
IP address or domain name of the DVRNS server.
Figure 47 — DVRNS setup screen.
NOTE: You will need to get the IP Address or domain name of the DVRNS Server from your network administrator.
You can use the domain name instead of IP address if you already set up the DNS Server when setting
up the LAN.
up the LAN.
Highlight the box beside Port and press the button. Set the port number of the DVRNS server using the Up and
Down arrow buttons to increase or decrease the numbers.
Down arrow buttons to increase or decrease the numbers.
Highlight Use NAT and press the button to toggle between On and Off.
NOTE: When using the NAT (Network Address Translation) device, refer to the NAT manufacturer’s instructions
for the proper network settings.
Highlight the box beside DVR Name and press the button. A virtual keyboard appears allowing you to enter the
DVR name to be registered on the DVRNS server.
DVR name to be registered on the DVRNS server.