Справочник Пользователя для TE Connectivity LAN Cat.6 UTP 0-0959385-3
Модели
0-0959385-3
108-93010
Product
Specification
Specification
14/Oct/2009 Rev E
Cat 6 Shielded Patch cords
2009 Tyco Electronics AMP España, S.A.,
Barcelona (Spain)
All International Rights Reserved
Barcelona (Spain)
All International Rights Reserved
1 of 5
* Trademark
| Indicates changes
| Indicates changes
LOC IK
1.
SCOPE
1.1
Content
This specification describes performance and material requirements and tests procedures for AMP
NETCONNECT* Cat 6 shielded patch cord assemblies used to connect building wiring for data and voice
networking systems.
1.2
Qualification
When tests are performed on subject product line, procedures specified in Figure 1 shall be used. All
inspections shall be performed using applicable inspection plan and product drawing.
2.
APPLICABLE DOCUMENTS
The following documents form a part of this specification to the extent specified herein. Unless otherwise
specified, the latest edition of the document applies. In the event of conflict between the requirements of this
specification and the customer drawing or any Tyco Electronics (TE) documents listed below, the customer
drawing and TE documents shall take precedence. In the event of conflict between the requirements of this
specification and the industrial standards, this specification shall take precedence.
2.1
Tyco Electronics Documents
A. Relevant customer drawing
B. 230-702:
B. 230-702:
Design for environment standard – ‘Supplier Requirements for the
Elimination of Hazardous Substances’
Elimination of Hazardous Substances’
C. 108-93018:
Product Specification - ‘Copper LAN cable’
2.2
Industrial Standards:
A. ISO / IEC 11801 2
nd
Edition:
Generic Cabling for Customer Premises
B. Amendment 2 to ISO/IEC 11801 2
nd
Edition.
C. EN 50173-1:
Information Technology; Generic Cabling Systems
D. ANSI/TIA/EIA 568-B.2-1:
Commercial Building Telecommunications Cabling Standard –
Part 2: Balanced Twisted Pair Cabling Components – Addendum 1:
Transmission Performance Specifications for 4-Pair 100Ohm
Category 6 Cabling
Part 2: Balanced Twisted Pair Cabling Components – Addendum 1:
Transmission Performance Specifications for 4-Pair 100Ohm
Category 6 Cabling
E. IEC 61935-1:
Generic cabling systems - Specification for the testing of balanced
communication cabling in accordance with ISO/IEC 11801. Part 1: Installed
cabling.
communication cabling in accordance with ISO/IEC 11801. Part 1: Installed
cabling.
F. IEC 61935-2:
Specification for the testing of balanced communication cabling in
accordance with ISO/IEC 11801. Patch cords and work area cords.
Test Specifications as indicated in Fig. 1.
accordance with ISO/IEC 11801. Patch cords and work area cords.
Test Specifications as indicated in Fig. 1.
G. IEC 61156-6:
Multicore and symmetrical pair/quad cables for digital communications –
Part 6: Symmetrical pair/quad cables with transmission characteristics up to
1000MHz – Work area wiring – Sectional specification.
Part 6: Symmetrical pair/quad cables with transmission characteristics up to
1000MHz – Work area wiring – Sectional specification.
H. IEC 60603-7-5:
Connectors for electronic equipment. Detail specification for 8-way, shielded,
free & fixed connectors, for data transmission with frequencies up to 250
MHz.
free & fixed connectors, for data transmission with frequencies up to 250
MHz.