Справочник Пользователя для Speco Technologies DVR-IP4CF

 

   

DVR-IP4CF 

 

 

11

When powered on, the DVR will auto-detect its peripherals (self-testing, warm-up, 

auto detects the hard disk and starts CF-card testing, and etc.)               

The system will detect the video input and judge whether the video system is 

NTSC or PAL. When video input is unable to be detected (VIDEO LOSS), the 

system will send out an alarm, press any button to stop the alarm (it will not affect 

the actual recording).    Always connect cameras to the DVR before powering up to 

properly detect the cameras. 

This mode is the default for our system after power on. Under this mode, system 

supports live view for monitoring. Press《REC》button, the system enters the record 

mode, press《PLAY》button to start playback, press《MENU》button to enter the menu 

setup display. During record or playback, press《STOP》button to stop the current 

activity and returns to monitoring mode. Under the main menu, press《MENU》 to 

return to monitoring mode.   

    During playback, press《STOP》button to return to monitoring mode.    Press FF 

to change the speed (FF1, FF2 or FF3), or press《REW》button to start reverse 

playback.  

 
~ To reset the DVR to factory defaults (under quad or single display), press

《PAUSE》button 5 times, the message《ALL SETTING DATA IS INITIALIZED.》

will be displayed by flashing 3 times, and after reset the password will be set as 

default value (111111).   

~ When the reset procedure has been completed, the message“DVR RESET 

COMPLETED. TURN THE DVR ON & OFF＂will be displayed, then please 

restart the DVR.