Справочник Пользователя для Speco Technologies DVR-16/IP

 

25

Alarm In   

 
1 Alarm In Detect                                OFF
2 Configuration Table 2 
3 Exit 

Release Time 

 
1 Motion RES Time                                  2
2 Video Loss RES Time                          2
3 Alarm In RES Time                           

       

10

4 Exit 

Clear Event List 

 
1 Clear Event List: No 
2 Clear Event List: Yes 
3 Exit 

 

Motion Detect 

 

 

 

 

Threshold: Day 

 

 
  

Threshold: 

Night 

 

This item allows you to setup the threshold of motion detection. 
The first bar shows the current detected amount of motion of this 
camera. The second and third bar allows you to setup the “day/ night 
threshold” (or “trigger level”), once the detected motion amount 
become larger than this level; the alarm will be triggered. 
 

This menu allows you to enable/ disable the Alarm pins of external I/O 
connector and to select N.O. (normal open) or N.C. (normal close) 
type for each pin.   
 

This item allows you to enable (YES) or disable (NO) the Alarm In pins. 
 

This item allows you to select N.O. (normal open) or N.C. (normal close) type for each Alarm In 
pins.  
 

This item allows you to enable/ disable the DVR-16/IP to detect Video Loss as an alarm event. 
 

This item allows you to enable/ disable the Alarm Set/ Reset signal of the external connector. If 
you select EN (enable), then you can force the alarm output to on/ off by using Alarm Set signal. 
 

This menu allows you to set the “release time” of alarm source: motion 
detection, video loss and alarm in. The release time defines how long 
time after the alarm trigger condition disappears; the same condition 
should be ignored to avoid false alarm being re-triggered.   
 

This menu allows you to clear event list. If you want to delete the 
event list, move your cursor to 2 Clear Event List: YES. If you want to 
keep the event list, move your cursor to 1 Clear Event List: NO. 
This arrangement is to avoid user clear the list by mistake.