Листовка для Coleman 9556-406K
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN VIETNAM
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent.
Condensation is caused by water vapor from your breath,
perspiration, or any wet clothing inside your tent. It is NOT
LEAKAGE through the tent fabric. It can be minimized by removing
wet clothing from your tent and by providing good ventilation
through the tent.
Condensation is caused by water vapor from your breath,
perspiration, or any wet clothing inside your tent. It is NOT
LEAKAGE through the tent fabric. It can be minimized by removing
wet clothing from your tent and by providing good ventilation
through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use separate storage bag.
inside your tent. Use separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE
STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT
STAKE LOOP TO REMOVE STAKE.
STAKE LOOP TO REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Do not leave your tent set-up for weeks at a time, be aware
that exposure to the ultraviolet rays of the sun can seriously
damage nylon material and/or cause it to become discolored.
damage nylon material and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flamma-
bility requirements of CPAI-84. The fabric may burn
if left in continuous contact with any flame source. The applica-
tion of any foreign substance to the tent fabric may render the
flame-resistant properties ineffective.
AWAY FROM THIS TENT FABRIC. This tent meets the flamma-
bility requirements of CPAI-84. The fabric may burn
if left in continuous contact with any flame source. The applica-
tion of any foreign substance to the tent fabric may render the
flame-resistant properties ineffective.
1
Layout & Positioning
of Tent
of Tent
–Layout and position tent with door
facing desired direction.
–Stake down tent keeping the
floor taut.
2
When You Are Ready To Set Up
Your Tent
Your Tent
–Select a level campsite clear
of rocks, branches and other
hard or sharp objects.
hard or sharp objects.
–Do not set up your tent
under trees.
Front and Rear Pole Assemblies
Front Door
Set-up Tent
–Insert pole tip through grommet at the peak of the
tent above the door.
–Raise the tent by pushing up on the pole until
you can place the bottom of the pole on the
ground. (illus. 2)
ground. (illus. 2)
–Stake out attached Guy Line directly
in front of tent.
–Repeat for opposite
end of tent
illus. 2
Tent shown
completely set-up.
Guy Line
Tent Pole in correct
position.
position.
Tent Stake Loops
PUP TENT
Instructions apply to Part Number 9556-406K
Part No. 9556-1051