Справочник Пользователя для Jonsered CS 2135T

English

 – 33

Following is a list of recommended cutting equipment for the Jonsered chain saw model CS 2135T. The combinations of power 
head, bar and chain have been tested and found to be in accordance with the kickback and vibration requirements of ANSI B 
175.1–2000.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding 
maximum nose radius of a hard nose.

The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also 
achieve kickback reduction.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide 
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be 
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar 
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the 
corresponding bar, see the table below.

12

3/8

0,050

9 T

Jonsered H36

45

14

3/8

0,050

9 T

52

16

3/8

0,050

9 T

56