Справочник Пользователя для Adtran 604

Section 4  User Interface Guide

Total Access 600 Series System Manual

 112

© 2004 ADTRAN, Inc.

61200624L1-1B

Displays the index number in the DLCI config table. The number range is 

.

When this parameter is set to 

 (def), the mapping is used to determine the protocols used. If set to 

 

the unit will ignore the virtual circuit with this DLCI.

Shows the user the physical and logical port associated with each DLCI. This is a read-only field.

The DLCI (Data Link Connection Identifier) number identifies the virtual circuit being configured. The 
DLCI range is 

. The default is 

 corresponding to the index numbers 

 respectfully.

Select the physical and logical method of data transfer over the virtual path. There are two valid connection 
entries: 

 and 

. Select 

 to connect traffic from this PVC to the Total Access 6XX 

integral IP router. Select 

 to connect traffic from this PVC to a voice connection (normally an FXS 

interface).

This submenu only appears for 

 connections. Configure the 

 for voice gateway using 

this menu.

The 

 setting is used to configure the correct Voice Gateway protocol for voice signaling 

control between the Total Access 6XX and the configured Gateway. The Call Control setting must be 
configured correctly before the voice circuits will work correctly. The Total Access 6XX supports 

, 

, 

 and 

 (def). 

View the status of the Copper Mountain DLCI connections.

Displays the index number for the Status menu entries.

This is a read-only field which displays the physical and logical port of the interface using the following 
nomenclature: [A.B], where A represents the physical port (network interface is 0, Ethernet is 1) and B 
represents the logical port for the Layer 2 protocol (i.e. PVC for Frame Relay, PPP link, etc.) Each 
configured logical port is assigned a number corresponding to the order in which they are listed in the L2 
Protocol configuration fields.