Справочник Пользователя для Nortel Networks 4027
DECT system configuration
44
Subscribing the handset to a DECT system
You must subscribe the handset to at least one DECT system before you
can use the handset to make a call. The handset can operate with a
maximum of four DECT systems, for which the handset stores the name
of the system in a subscription record. The subscribed name appears on
the handset display whenever the handset enters the range of the DECT
system.
can use the handset to make a call. The handset can operate with a
maximum of four DECT systems, for which the handset stores the name
of the system in a subscription record. The subscribed name appears on
the handset display whenever the handset enters the range of the DECT
system.
Before you subscribe to a DECT system, obtain the following information
from your system administrator:
from your system administrator:
•
PARK code: Use a PARK code system ID only if more than one
DECT system overlaps in your location.
DECT system overlaps in your location.
•
DECT system name: The name of the system to which you subscribe.
After you enter the system name, it appears on the idle display.
After you enter the system name, it appears on the idle display.
•
Phone number: The local phone number assigned to your DECT
handset.
handset.
To subscribe your handset to a DECT system, perform the following
steps:
steps:
Attention: If your supplier preinstalls the handset, you need not
subscribe your handset to a system. When the handset is
not yet subscribed to a system, the message “Register”
appears on the display screen.
not yet subscribed to a system, the message “Register”
appears on the display screen.
Use the PABX-PIN code to register the handset with a
DECT system.
DECT system.
Attention: As soon as you have obtained information about your PIN
code, you have only 15 minutes to subscribe the handset
set. In 15 minutes the PIN code is deactivated and it is
necessary to activate a new one.
set. In 15 minutes the PIN code is deactivated and it is
necessary to activate a new one.
1.
Open the
Connectivity
menu as shown in
.