Справочник Пользователя для Avaya 3600 Series

Initiating a call  Press the 

 button and wait briefly to activate the channel 

before talking. You may begin talking when the display shows 
“Transmitting.”. 

Transmitting  Once a call has been initiated, hold the WT two inches from your 

mouth and talk into the microphone. When the 

 button is 

released, the 3626 WT then enters the waiting state where it 
monitors the channel for up to ten seconds. 

Initiate subsequent transmissions by pressing the 

 button on 

any 3626 WT using the same channel. The user can start talking 
immediately.  The display screen shows the current active 
channel.. 

If no transmission occurs during the ten-second countdown 
period, the 3626 WT reverts to the idle state. 

Receiving  Upon receiving a PTT transmission, the phone plays the 

“receiving alert” sound and enters the receive state. 

In this state the phone receives all conversations on the selected 
channel.  The phone will ignore the 

 button while in the 

receive state.  The screen shows the current active channel, the 
caller ID information of the current transmitter, and an indication 
that the phone is receiving a broadcast transmission.  The caller 
ID is protocol specific. In most cases it is simply the extension 
number programmed in the phone from the on-hook user menu. 

At the end of a transmission, the phone enters the waiting state 
where it monitors the channel for up to ten seconds and displays 
“Waiting” on the screen.  If no other transmission occurs within 
ten seconds the phone reverts to idle state. 

Change PTT volume  Use the 

 and 

 buttons to raise or lower PTT volume. A 

separate volume is maintained for PTT calls with the current 
volume selection retained in memory. 

Muting a PTT call  To mute a current call, press the 

 soft key.  This brings up a 

 prompt. Press the 

 or 

 soft key. 

The prompt disappears after 3 seconds if the user doesn’t confirm 
either 

 or 

. 

Mute only affects the current call and the phone will play 
subsequent PTT calls. Mute does not allow the user to use the 
WT’s keypad for anything else, including an OAI application. 

The 

 soft key turns into an 

 soft key while in the 

mute state and can be used to unmute the PTT call (the 
confirmation prompt is displayed first). 

When the next PTT call period starts the audio is automatically 
unmuted. 

In order to terminate incoming broadcasts, press the 

 

soft key and answer 

 to the confirmation prompt.  Push-to-

talk audio is immediately stopped and the phone exits the PTT 
session. No other WT is affected. Only the current call is 
terminated for this handset. When the next PTT call period starts, 
the WT is again in the receive state. You may rejoin a still-active 
session by initiating a PTT call.

 

Users should disable the PTT feature in the on-hook user menu if 
it is desired to not receive any further PTT calls. 

21-300632, Issue 1, July 2005 

Page 18