Справочник Пользователя для AT&T System 85

Скачать
Страница из 751
ISDN 8520T Voice/Data Terminal
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
3. The display screen shows you the current terminating resistor setting (IN or OUT).  Use
the softkeys to toggle between the two settings, whichever is correct for that terminal.
4. When the correct setting is shown on the display screen, press the softkey beside  Done.
Switch Administration
An 8520T voice/data terminal connected to a DEFINITY G2, G3i, or G3r should be aliased as a
7507 with data.
Button Numbering
d
When the terminal is connected to a DEFINITY G3, the 20 call appearance/feature but-
tons should be administered as ‘‘BUTTON ASSIGNMENTS’’ 1 through 20.
Note:
On a DEFINITY G3 switch, the Normal or Exit feature should be admin-
istered on Button #21.
d
When the terminal is connected to a DEFINITY G2, the call appearance/feature buttons
should be administered as ‘‘BUTTON ASSIGNMENTS’’ 3 through 22.
The Service Profiler ID (SPID)
When ISDN terminals are initially installed, a unique SPID number must be entered into the ter-
minal.  This number identifies the terminal to the network.  Usually, the system manager provides
the SPID for each terminal in the system.  Use the following procedure for entering the SPID in
an ISDN 8520T terminal.
1. Press 
cbbbbbbbbc
bbbbbbbb
Menu  
and then press 
cbbbbbbbbc
bbbbbbbb
Mute  
.
2. Dial the numbers, ‘‘43’’ (ID).
3. Press 
cbbbbbc
bbbbb
*  
on the dial pad.
4. Enter digits from the dial pad for a new SPID number.  If, at any point, you make a mis-
take, press 
cbbbbbc
bbbbb
*  
to erase the number and re-enter the SPID.
5. When the SPID number is correct, press 
cbbbbbc
bbbbb
#  
on the dial pad to save the new SPID in
the terminal.
3-440