Инструкции Пользователя для Mitsubishi Electronics WS-65909
50
50
Part III: Setup
Passcode Screen
(Figure 2)
To view a V-Chip blocked program or to
watch the program during a scheduled lock
time, you must enter your 4-digit passcode
time, you must enter your 4-digit passcode
or change the channel to an unlocked pro-
gram. Once you have entered the passcode,
the V-Chip block or Lock by Time will remain
released until the TV is powered off and
then on again.
gram. Once you have entered the passcode,
the V-Chip block or Lock by Time will remain
released until the TV is powered off and
then on again.
V
-C
h
ip
L
o
c
k
If you forget your four-digit passcode,
see Appendix A, page 71.
V-Chip Lock Menu: Passcode
V-Chip
(Figure 3)
V-Chip allows you to Block or Allow pro-
grams based upon rating signals sent by the
broadcasting station. The TV comes from
the factory with the V-Chip in the Off setting.
broadcasting station. The TV comes from
the factory with the V-Chip in the Off setting.
You can turn the V-Chip on within the V-Chip
Menu or you can use the V-CHIP button
on the remote control to conveniently turn
the V-Chip on or off. The factory preset is
on the remote control to conveniently turn
the V-Chip on or off. The factory preset is
TV-PG for TV ratings or PG for movie ratings,
allowing only programs rated TV-PG/PG or
lower. You can change the blocking level
to various TV ratings and lettered categories
or movie ratings. After changing channels
or devices, there may be up to a 5 second
delay before the V-Chip lock takes effect.
lower. You can change the blocking level
to various TV ratings and lettered categories
or movie ratings. After changing channels
or devices, there may be up to a 5 second
delay before the V-Chip lock takes effect.
Entry
(Figures 1)
The rst tim
e you sel ect V- Ch i p Lock f rom
the MAIN menu, or after you have canceled
your passcode you will see the screen
shown in gur e 1. Af ter set ting a passcode,
the next time you select V-Chip Lock from
the MAIN menu, you will see “a new”
replaced by “your.” Use the number buttons
on the remote control to input a four-digit
passcode, then press ENTER. You can
delete a number and move back one space
by pressing CANCEL. You can exit without
inputting a passcode by pressing MENU or
HOME.
the next time you select V-Chip Lock from
the MAIN menu, you will see “a new”
replaced by “your.” Use the number buttons
on the remote control to input a four-digit
passcode, then press ENTER. You can
delete a number and move back one space
by pressing CANCEL. You can exit without
inputting a passcode by pressing MENU or
HOME.
Figure 1. V-Chip Entry Screen
Figure 3. V-Chip menu
V-Chip Start Time and V-Chip Stop
Time
(Figure 2)
Select the times you would like the V-Chip to
be Active. By setting the V-Chip Start Time
and V-Chip Stop Time to the same time, the
and V-Chip Stop Time to the same time, the
V-Chip will be active 24 hours a day.
Press or to slowly adjust the time.
Press and hold or to quickly adjust the
Press and hold or to quickly adjust the
time.
Figure 2. V-Chip Blocked Channel passcode screen