Инструкции Пользователя для Mitsubishi Electronics WS-65515

86

87

Appendix G: Diamond Shield™ Removal for Models 

WS-48515, WS-55515,  WS-55615, WS-55615A, WS-65515, 
WS-65515A WS-65615, WS-65615A  

WARNING

Sharp edges!  Always wear gloves to 
handle, lift, remove and install  the    
Diamond Shield and molding clips.

For the WS-48515:

1.  Insert a plastic card, like a credit card at the top 

right or left side of the screen between the molding 

clip and the Diamond Shield.  Pull towards you to 

loosen the clip.  Then, very carefully, insert a flat 
head screwdriver into the space at the top of the 
molding clip and gently pull towards you.  After 
unsnapping the top, the rest of the clip should be 
unsnapped by hand.   Do not use force.  Both the 
right and left side clips must be removed.  Proceed 
to steps 2-4.

For the WS-55515, WS-65515 and  WS-65515A:

1.  Remove the left and right side molding clips by 

inserting a plastic card, like a credit card between 
the molding clip and screen, at the top, middle and 
bottom.  After loosening the clip with the card, pull 
on a corner of the clip closest to the screen.  Do 
not use force, the clips should slide out of place. 
Both the right and left side clips must be removed.  
Proceed to steps 2-4.

The Diamond Shield for the WS-48515, WS-55515,WS-55615, WS-55615A, WS-65515, WS-65515A, WS-65615 and 
WS-65615A comes installed by the factory.  If you prefer, it can be removed using the steps on these pages.  The 
molding clips can only be removed as described for your specific model.  Incorrect removal of the molding clips can 
damage the Diamond Shield.

For additional assistance, call 
(800) 332-2119.