Справочник Пользователя для Mitsubishi Electronics WS-55815

88

89

Appendix G: Diamond Shield™ Removal for WS-55815
 

 

 

Diamond Shield Installation for WS-65815

WARNING

Sharp edges!  Always wear gloves to 
handle, lift, remove and install  the    
Diamond Shield and molding clips.

Molding Clip Removal for WS-55815 and WS-65815

1. Remove the left and right side molding clips by 

inserting a plastic card, like a credit card between 
the molding clip and Diamond Shield, at the top, 
middle and bottom.  After loosening the clip with 
the card, pull on a corner of the clip closest to the 
Diamond Shield.  Do not use force, the clips should 
slide out of place. Both the right and left side clips 
must be removed.  For the WS-55815, go to steps 
2-4, for the WS-65815, go to steps 5-7.

For additional assistance, call 
(800) 332-2119.

Diamond Shield Removal: 
2.  To remove the Diamond Shield, slide it out of the 

channels, starting with the top.  Gently bow the 
Diamond Shield towards you and push the top out 
of the channel, then lift straight up to remove it from 
the bottom channel.

3.  Wipe off any dust with a lint-free cloth and store 

the shield carefully where it will not be scratched. 
Do not use any cleaners on the anti-glare Diamond 
Shield. This completes the Diamond Shield removal.  

4.  Re-install the molding clips for a finished look, by 

pushing them back into place, starting at a corner.  
Do not use force. 

To install the Diamond Shield, follow steps 1 and 5-7.

Diamond Shield installation:  
5. Carefully remove the Diamond Shield from the 

protective packaging.  Wipe off any dust with a  
lint-free cloth.  Do not use any cleaners on the  
anti-glare Diamond Shield.

6. Insert the shield by sliding it into the bottom channel.  

Gently bow the Diamond Shield toward you and 

insert the top of the Diamond Shield into the top 
channel.

7.  Re-install the molding clips for a finished look, by 

pushing them back into place, starting at a corner.  
Do not use force.  This completes the Diamond 
Shield installation.

To remove the Diamond Shield, follow steps 1 and 2-4.