Справочник Пользователя для Mitsubishi Electronics WD-52627

The shaded buttons on the front control panel are duplicated on the remote control.  The top row of labels shows the 

control functions when there are no TV menus displayed on the screen.  The bottom row of labels shows the control 

functions when the TV menus are displayed on the screen or when a special function has been activated.  See 

“Remote Control Overview” for further details on the functions of these buttons.

<

DEVICE

GUIDE

CANCEL

MENU

ENTER

MENU

FORMAT

– CH –

<

>

ADJUST

– VOL –

<

>

>

<

>

POWER

SYSTEM

RESET

LAMP

STATUS

TIMER

If the TV does not respond to either the remote control or the front panel controls and/or 

does not power Off, press the SYSTEM RESET button with a pointed item like the end 

point of a paperclip.  The TV will turn Off and the TIMER light will flash quickly for about 

one minute.  When the TIMER light stops flashing, you may again turn on the TV.  The 

changes you made the last time the TV was on before you used the SYSTEM RESET 

button may be lost; any changes that were previously saved are not lost, however.

<

DEVICE

GUIDE

CANCEL

MENU

ENTER

MENU

FORMAT

– CH –

<

>

ADJUST

– VOL –

<

>

>

<

>

POWER

SYSTEM

RESET

LAMP

STATUS

TIMER

There may be times when you wish to reset the A/V (Audio and Video) settings back to the factory defaults.  To 

return all of the settings at once, press GUIDE and FORMAT on the front panel at the same time.  To reset the 

defaults for individual devices, use the A/V Memory Reset selection on the Audio/Video menu.

<

DEVICE

GUIDE

CANCEL

MENU

ENTER

MENU

FORMAT

– CH –

<

>

ADJUST

– VOL –

<

>

>

<

>

POWER

SYSTEM

RESET

LAMP

STATUS

TIMER

None (indicator 
off)

TV is powered OFF.

Normal operation.

Green, steady

TV is powered ON.

Normal operation.

Green, rapid 
blinking

1.  TV just plugged into AC outlet.

Wait until blinking stops before turning on 
(approximately 1 minute).  Normal operation.

2.  AC just restored after power failure. Wait until blinking stops before turning on 

(approximately 1 minute).  Normal operation.

3.  TV Rebooting after System Reset 

used.

Wait until blinking stops before turning on 
(approximately 1-2 minutes).  Normal operation.

4.  TV Rebooting after power 

fluctuation or receiving abnormal 
digital signals from digital channel, 
CableCARD™, or digital device.

Wait until blinking stops before turning on 
(approximately 1 minute).  Normal operation.

5.  You have begun the procedure to 

update software from an authorized 
flash memory device.

For detailed information, see the instructions 
that accompany the authorized software update.  
Important:  Do not use non-authorized software at 
any time.

Green, slow 
blinking

TV powered off and automatic-on 
timer is set. 

Normal operation.  TV can be turned on at any 
time.