Справочник Пользователя для Mitsubishi Electronics WD-52627

When a NetCommand pre-memorized or learned IR 
controlled A/V receiver has been connected to the TV 
and added to NetCommand Setup, an AVR icon will 
appear in the audio section.  Press AUDIO  to change 

navigation to the audio section.  Then press ADJUST 

        to select the TV speakers icon or the A/V 

receiver icon.  Press ENTER to change the audio 
selection.  Press DEVICE to return the navigation to the 
Device Section.

Devices that have separate On and Off remote control 
buttons will power On automatically when you select 
the device and will power Off when you turn off the TV.  
For devices that do not power On or Off automatically, 
display the Device Selection menu, press ADJUST   
or   to highlight the device icon and press POWER on 
the remote control.  For the A/V receiver, press AUDIO 
to move the navigation to the Audio Section.  Highlight 
the A/V receiver icon and press POWER.  If you 
press POWER on the remote control when the Device 
Selection menu is not displayed, the TV will turn Off.

To select another device or input, press ADJUST          

        on the TV’s remote to move the highlight.  

Press ENTER to select the device to view and 
hear.  The TV inputs are automatically changed.  If 
NetCommand is set up, the inputs on compatible A/V 
receivers are automatically changed at the same time.

The destination of the device highlighted in the Device 

Section is displayed here as a TV icon.

The Connection Section shows the recording in 

progress and the device that is recording from the 
source.  For example, if the Digital VCR (D-VCR) is 
currently recording, when you move the highlight 
to the Ant-1 icon, the D-VCR icon will appear in the 

Connection Section.  This icon will disappear when 
you move the highlight to another icon, press CANCEL 
to stop recording.

When you press DEVICE on the TV’s remote control, the Device Selection menu (Figure 7) displays.  If NetCommand® 

has not been set up, the Device Selection menu allows you to select an input for viewing.  If NetCommand is set up, the 
Device Selection menu allows you to select the device for viewing, select audio from the TV speakers or A/V receiver, 
power compatible devices On or Off, and verify the destination of signals. On the Device Selection menu, the device or 
input currently displayed appears as a gold-colored icon.   

The PIP Selection menu displays when you press the 

PIP DEVICE button on the remote control.  This menu 
has the same general format as the Device Selection 
menu.  The source for the Video Section is the sub 
picture and the Audio and Connection Sections are not 
available.

Use ADJUST          to move the highlight to the 
device to show in the PIP screen, then press ENTER.  
Device icons that are grayed out are not available for 
use as PIP sources or with the current source.