Справочник Пользователя для Mitsubishi Electronics WD-52627

The Record menu allows you to setup recordings, view 

the record list and set defaults for your recording devices.

The recording Setup menu is where you tell the TV what, 

where, and when to record.  There are two ways to open 
the Recording Setup menu:

•  by selecting Record from the Record menu.
•  by pressing REC on the remote control.

Your TV is able to start and stop recordings automatically 

and send the signals from one external playback device 
to another external recording device.  It is also able to 
convert digital channels and IEEE 1394 device signals to 
analog signals that can be recorded on NetCommand-
compatible analog VHS and S-VHS VCRs connected to 
the record audio and video outputs on the back of the TV.

You can schedule the recording to take place at a later 

time and program the recording duration for a minimum 
of 30 minutes and a maximum of 6 hours (in 30-minute 
increments).  The default is 1 hour.

When a digital recording is being made, the TV will either 
direct the signals to the recording device using the IEEE 

1394 cable.  In the case of an analog recording (as to a 

VCR) the TV converts the digital signals to analog format 

and sends the analog output to the VCR through the 
RECORD OUTPUT jacks.

Recording Now
Can be used when viewing Antenna 1 or 2, an IEEE 1394 

device, or a non-recording traditional device. 

To initiate recording now:
1.  Press REC (record) on the TV remote or press 

ENTER if the Record menu is displayed.

2.  Review the Record To (destination) device (VCR) and 

duration.  Change if necessary.

3.  Press REC a second time to initiate recording.

To initiate a time-delayed recording:
1.  Press REC (record) on the TV remote or press 

ENTER if the Record menu is displayed.

2.  Press ADJUST   or   to select the channel, device 

to record to, duration time, start time (press ENTER 
after selecting hour and minutes to set the time) and 
day.

3.  Select Add and press ENTER to add the recording 

to the record list.  If your selection is successful, a 
confirmation message will be displayed.  If you pick 
overlapping times, day(s), or destination devices, 
you will see a message stating there is a conflict.

4.  To exit, press HOME on the TV remote after all 

recordings have been added.

During the recording, the TV can be powered Off. 

To prevent recording of unwanted material while 

recording to a VCR or A/V disc, press PAUSE to 
temporarily stop recording.  Press PAUSE again to 
resume recording.

You cannot record from an analog channel or device or a 

VHS or S-VHS VCR to a digital recording device such as 

a DVCR or A/V Disc.