Справочник Пользователя для Mitsubishi Electronics WD-52627

To view a V-Chip blocked program or to watch the 

program during a scheduled lock time, you must enter 
your four-digit pass code or change the channel to an 
unlocked program.  Once you have entered the pass 
code, the V-Chip block for that channel or Lock by Time 
will remain released until the TV is powered Off and then 

On again.

Channel is locked.

V-Chip locked the program because the rating is

TV-PG DSLV

To watch the program, Enter your passcode.

– – – –

Use the NUMBER buttons and press ENTER.

Select V-Chip Lock to perform the functions listed below.  
V-Chip allows you to Block or Allow programs based 
upon rating signals sent by the broadcaster.  The TV 
comes from the factory with the V-Chip Lock in the Off 
setting.

You can turn the V-Chip on within the V-Chip Menu or 

you can use the V-CHIP button on the remote control to 
conveniently turn the V-CHIP on or off.  

The factory preset is TV-PG for TV ratings or PG for 

movie ratings, allowing only programs rated TV-PG/PG 

or lower.  You can change the blocking level to various 

TV ratings and lettered categories or movie ratings.  After 

changing channels or devices, there may be up to a 5 
second delay before the V-Chip lock takes effect.

You will see the screen shown in Figure 20 when you 

press V-CHIP on the remote control, the first time you 
select the V-Chip Lock menu, or after you have canceled 
your pass code.  To use the Lock, input a four-digit pass 
code with the number buttons on the remote control, then 
press ENTER.  You can delete a number and move back 
one space by pressing CANCEL.  You can exit without 
inputting a pass code by pressing MENU or HOME.

After setting a pass code, the V-Chip Lock is active.  The 

next time you select V-Chip Lock you will see “...enter 

your pass code” instead of “...enter a new pass code.” 

V-CHIP is OFF.

The rating is set to

TV-PG

To turn V-Chip on, enter new passcode.

– – – –

Use the NUMBER buttons and press ENTER.

Select the times you would like the V-Chip to be active.  
By setting the V-Chip Start Time and V-Chip Stop Time to 
the same time, the V-Chip will be active 24 hours a day.
Press ADJUST   or   to slowly select the time, starting 
with the hours.  Press and hold ADJUST   or   to 
quickly select the hours, press ADJUST    to select the 

minutes.