Справочник Пользователя для Mitsubishi Electronics 737 SERIES

Turn off TV power and unplug the TV.  Allow the 

lamp to cool for at least one hour before proceed-
ing.
After the lamp has cooled, remove the cover of the 

lamp compartment, located on the back of the TV.
Refer to figures 1 and 2.  Use a #2 (medium) Phillips 
screwdriver to loosen the screw securing the cover.

  

Keep the screw and cover for re-installation
Wi

th a medium Phillips screwdriver, loosen the two 

screws securing the lamp cartridge until they dis-
engage from the mating threads.  These are captive 
screws and cannot be separated from the lamp 
cartridge.
Fully open the bag supplied with the replacement 

lamp and set the opened bag aside.
Gently grasp the handle of the lamp cartridge and 

pull the old cartridge straight out.  See figure 3.

CAUTION:  Do not tilt or rotate the cartridge, as 
small glass fragments may fall out.

Without tilting or putting down the lamp cartridge, 

insert it into the opened bag.  Close the bag while 
being careful not to let any glass particles fall out.

Do not touch the glass parts of the new lamp car-

tridge.  Insert the new cartridge into the TV in the 
same orientation as the old cartridge.  Push on the 
cartridge housing until it is fully seated.
Gently tighten the screws with the screwdriver.  

AVOID OVERTIGHTENING!
Replace the plastic cover and retaining screws.

WASH YOUR HANDS THOROUGHLY, AS THIS 

LAMP CONTAINS MERCURY.

Disposal of the Old Lamp Cartridge
Lamp under warranty:  All lamps replaced under war-
ranty must be returned to Mitsubishi.  Use the return 
shipping label provided and send to Mitsubishi Digital 
Electronics, America, 625 Braselton Parkway, Suite 200, 
Braselton, GA 30517.

Lamp no longer under warranty:  Contact your 
local authorities or the Electronic Industries Alliance at 
www.eiae.org for lamp-disposal or recycling instructions.  
Do not dispose of the old lamp with common trash.

Lamp-Cartridge Filter Cleaning
If the TV shuts off after displaying the message “TV 
will shut down in a few seconds.  Please check if the 
air flow is blocked” and/or the 

STATUS LED is yellow, the 

air filter may need cleaning.  The air filter is part of the 
lamp cartridge.  Use the following procedure to clean 
the filter.

Remove the lamp cartridge from the TV as 

described under “Removing the Old Lamp Car-
tridge.”  Do not tilt or rotate the cartridge.  Do not 
touch the glass parts of the lamp cartridge.
Holding the lamp cartridge horizontal (do not tilt or 

rotate), use a soft dry brush or vacuum cleaner to 
remove any dust that may be present on the mesh 
filter.  Do not use liquids.  See figure 4.
Reinstall the lamp cartridge as described under 

“Installing the New Lamp Cartridge.”