Справочник Пользователя для Barco PGXG-61B
40
PGXG-61B/PGWX-61B/PGWU-61B - - 2015/04/01
5. Troubleshooting
Image is unstable or flickering
y
Use “
-
TIMINGS\H PHASE” to correct it.
Change the monitor color setting on your computer.
-
Image has vertical flickering bar
y
Use “
-
AUTO IMAGE” to make an adjustment.
Check and reconfigure the display mode of your graphic card to make it compatible with the projector.
-
Image is out of focus
y
Adjust lens focus to fit.
-
Make sure the projection screen is between the required distance.
-
The image is stretched when displaying 16:9 DVD title
y
When you play anamorphic DVD or 16:9 DVD, the projector will show the best image when the projector
-
display mode is set to 16:9 in the OSD.
If you play 4:3 format DVD titles, please change the format to 4:3 in the projector OSD.
If you play 4:3 format DVD titles, please change the format to 4:3 in the projector OSD.
-
If the image is still stretched, you will also need to adjust the aspect ratio by referring to the following:
-
Please setup the display format as 16:9 (wide) aspect ratio type on your DVD player.
-
Image is too small or too large
y
Adjust lens zoom to fit. If it does not fill the screen properly, please change the correct lens or change the
-
position of the projector.
Image has slanted sides
y
Reposition the projector so that it is perpendicular to the screen.
-
Lamp burns out or makes a popping sound
y
When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens,
-
the projector will not turn on until the lamp module has been replaced.
5.2 LED Indication Chart
1 sec
1 sec
1 sec
1 sec
1 sec
Off/STBY
On
Error
During Start-up
Status LED