Справочник Пользователя для Vidikron Vision 150

Use the Service menu to access advanced projector configuration settings. This menu 
should be used by ISF-certified technicians only.

Test Video: Select Test Video from the Service Menu to access the internal test patterns on 
the Vision 140/150. Four patterns are available, consisting of white/gray or colored bars. 

Press MENU to exit test pattern mode. 

 

 

 

 

Input Names: You can give each VHD Controller input a descriptive name. For example, you 
may want to change the default input name to the type of source component connected to 
it: “VCR,” “DVD,” “Laptop” et cetera. Composite, S-Video and Component SD input names can 
be up to 12 characters long; the others can be up to eight characters long. 

To edit an input name, select Input Names from the Service menu. Press 

 or 

 to select an 

input and press ENTER. Use the 

 or 

 buttons to change a character; press 

 or 

 to 

select a character to change. When you have finished editing the input name, press MENU. 

To restore the default input name, press 

 repeatedly to highlight that input name in the 

“Restore” column. Then, press ENTER. 

To save input names so that they can be restored after a System Reset (described on 
page 79), press 

 repeatedly to highlight “Save.” Then, press ENTER. 

Remote Control: The Remote Control menu shows you the primary and secondary infrared 
(IR) codes to which the VHD Controller will respond. By default, both are set to 17. You can 
change these codes if either:

•

Another device in the theater (a DVD player, for example) is responding to commands 
from the VHD Controller remote control (Figure 2-6) in ways that are unpredictable or 
undesirable. 

•

You have multiple VHD Controllers and want to control them independently, as opposed 
to broadcasting commands from a single remote to all of them. In this scenario, you can 
use multiple remotes programmed to use different IR codes. Or, you can use a single 
remote and change the IR code as needed to address a specific device.

➤

 button takes you from top to bottom in the left column, then from