Справочник Пользователя для Sanyo POA-PN02C

 This product provides a serial control port to control the external equipment  through the 
serial cable. This function allows you to control the external equipment connected to the 
serial port on the network unit through the network, and control the projector through the 
serial cable with the external serial controller. Before connecting the external equipment, 
perform the setting "Serial Port setting" described below.

This is to set up the serial port on the network unit. Display the setting 
page by clicking Serial Port setting sub menu in the Initial setting 
menu. To communicate with external equipment correctly, communica-

tion condition must be set up to the same values as that the connected equipment is 
using. When clicking on any item of the serial port setting, the setting pallet appears and 
set up each item and then click Set button*

1

.

Baud rate ............... Communication speed for serial port, select with the pull-down menu (300 ~ 115200)

Parity ........................ Parity check, the ways for error detecting of the transferred data (None, Odd, Even)

Stop bit ................... Stop bit, Select the end of communication (1 or 2)

Flow control ........Ways for communication flow (None, Xon/Xoff, RTS/CTS)

Data length ......... Selects the length of data (7 or 8)

Serial control ......Selects equipment to control (External or Projector)

 

External ............ Used to select when the external equipment connected to the serial 

port is controlled by the computer through the LAN port.

 

Projector ......... Used to select when the projector is controlled by the serial controller 

connected to the serial port.

Port number .......  Specifies the port number of TCP/IP. The default number is 23. Use the same port 

number specified by application. There are some reserved port numbers*

1

. If one of 

those port numbers is used, the alert dialog window will appear and let you know 

that it is an invalid port number.

✐

    This product will restart when "Port number" or "Serial Control" is changed and it takes about 20 

seconds.