Справочник Пользователя для Mitsubishi Electronics IB-1500193(ENG)-D

7 - 9

Contact Mitsubishi branch or your dealer for an order or a replacement of the drive unit.

Place an order for the same type of a drive unit as the one to be replaced.

Replace the drive unit with the following procedures.

[1] Turn the breaker for the input power OFF. Make sure the CHARGE lamp of the power supply unit is 

turned OFF. 

[2] Disconnect all the connecters and the wires connected to the drive unit. 

[3] Remove the two (four) screws fixing the drive unit onto the control panel. Remove the drive unit 

from the control panel.

[4] Make a same setting for the rotary switch and the dip switch of the new drive unit as those of the 

uninstalled drive unit.

[5] Install a new drive unit by following the removal procedure in reverse.

Data backup and restoration is not required before replacing drive units because drive units’ data such 

as parameters are stored in the controller. However, carry out a backup of the whole system before 

replacement as a precautionary measure.

The power for keeping the detector’s position data of an absolute position system is supplied from the 

battery connected to the drive unit. Keep the power ON once for 30 minutes or more if possible, and 

make sure to complete the replacement within 60 minutes after charging the detector’s capacitor.