Справочник Пользователя для Runco VX-3000D
VX-3000d Series Installation/Operation Manual
39
PRE
L
IMINAR
Y
For a floor (non-AutoScope) installation, turn
the four adjustable feet on the bottom of the
projector to adjust the projector height and/or
projection angle.
the four adjustable feet on the bottom of the
projector to adjust the projector height and/or
projection angle.
If you do tilt the projector, you may need to
apply keystone correction or vertically shift the
image using the on-screen display (OSD)
controls, to compensate. For detailed
instructions, refer to Using the On-Screen
Menus on page 61.
apply keystone correction or vertically shift the
image using the on-screen display (OSD)
controls, to compensate. For detailed
instructions, refer to Using the On-Screen
Menus on page 61.
3.7
Connections to the
VX-3000d and DHD
Controller
Connections to the
VX-3000d and DHD
Controller
Proceed as follows to connect the DHD Controller to the VX-3000d, your video sources,
external controller(s) – if present – and AC power.
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel Access
To access the connector panel, pull
firmly on the cable access cover to
open it.
firmly on the cable access cover to
open it.