Справочник Пользователя для Runco V-63HD
Vistage™ Series Flat-Panel Display Installation/Operation Manual
7
PRE
L
IMINAR
Y
The rear-panel connectors reside behind protective cover plates with cable routing slots.
Use a Phillips screwdriver to remove the plates in order to connect cables, and to
re-attach them afterward.
Use a Phillips screwdriver to remove the plates in order to connect cables, and to
re-attach them afterward.
1.
AC POWER INPUT
Connect the V-50HD/V-63HD to AC power here.
Connect the V-50HD/V-63HD to AC power here.
2.
DHD INPUT PANEL
• SECONDARY INPUT
For future use.
• SERVICE PORT
For future use.
• PRIMARY INPUT
HDCP-compliant digital video input. Connect the HDMI output from the DHD
Controller to this input.
Controller to this input.
2.2
DHD Controller Front
Panel
DHD Controller Front
Panel
Figure 2-4 shows the controls and indicators on the DHD Controller front panel; the
paragraphs that follow describe them.
paragraphs that follow describe them.
Figure 2-4. DHD Controller Front Panel
1.
STATUS LED
Indicates DHD Controller status as follows:
Indicates DHD Controller status as follows:
• Solid yellow = DHD Controller is in standby mode (off)
• Flashing blue = DHD Controller is starting up
• Solid blue = normal operation
• Off = DHD Controller is shutting down (“cool-down” mode)
• Flashing yellow = error condition
• Alternately flashing blue/yellow = firmware upgrade in progress
2.
REMOTE CONTROL SENSOR
Receives the signals from the remote control.
Receives the signals from the remote control.
To minimize the amount of space required behind the panel when
wall-mounted, the connectors are recessed and right-angled
relative to the rear panel surface (the AC input faces right and the
other input connectors face downward).
wall-mounted, the connectors are recessed and right-angled
relative to the rear panel surface (the AC input faces right and the
other input connectors face downward).
Note
1
2