Справочник Пользователя для Cannon 10 STX TS

 

www.cannondownriggers.com 

Installation 

Decks thinner than 1/4" 
 

Use a Cannon deck plate (PN 2200693) to prevent 

deflection and add stability to decks thinner than 1/4". 
Use the deck plate as a template to mark the hole 
locations. 

 

If access to the underside of the deck is not 

available, the deck plate can be mounted using screws 
and wellnuts. Use the deck plate as a template to mark 
locations and drill 4 wellnut clearance holes. Use four 
1/4-20 x 1-1/2" flat head screws and four wellnuts to 
mount deck plate. Tighten the screws so the wellnuts 
are firmly compressed. 
 

Where the underside is accessible, the deck plate 

can be mounted using screws, nuts, and washers. Drill 
9/32" holes. Use four 1/4-20 x 1-1/2" flat head screws, 
nuts and washers (flat and lock). Fasten plate to deck. 
To secure the mounting base to the deckplate use four 
1/4-20 x 1" truss head screws. 
 
NOTE: When using the telescopic boom, we 
strongly recommend the use of a deck plate on all 
boats to provide adequate stability for the 
downrigger. 

The Low-Profile Swivel Base mounting follows the same 
procedure as for the deck plate except that four 1/4"-20 
x 1-1/2" truss head screws are used to fasten the 
mounting base and four additional 1/4"-20 x 2" truss 
head screws fix the swivel base to the boat deck.