Справочник Пользователя для Silicon Laboratories C8051F342

The SMBus Configuration register (SMB0CF) is used to enable the SMBus Master and/or Slave modes, 
select the SMBus clock source, and select the SMBus timing and timeout options. When the ENSMB bit is 
set, the SMBus is enabled for all master and slave events. Slave events may be disabled by setting the 
INH bit. With slave events inhibited, the SMBus interface will still monitor the SCL and SDA pins; however, 
the interface will NACK all received addresses and will not generate any slave interrupts. When the INH bit 
is set, all slave events will be inhibited following the next START (interrupts will continue for the duration of 
the current transfer).

The SMBCS1-0 bits select the SMBus clock source, which is used only when operating as a master or 
when the Free Timeout detection is enabled. When operating as a master, overflows from the selected 
source determine the absolute minimum SCL low and high times as defined in Equation 17.1. Note that the 
selected clock source may be shared by other peripherals so long as the timer is left running at all times. 
For example, Timer 1 overflows may generate the SMBus and UART baud rates simultaneously. Timer 
configuration is covered in 

.

The selected clock source should be configured to establish the minimum SCL High and Low times as per 
Equation 17.1. When the interface is operating as a master (and SCL is not driven or extended by any 
other devices on the bus), the typical SMBus bit rate is approximated by Equation 17.2.

0

0

Timer 0 Overflow

0

1

Timer 1 Overflow

1

0

Timer 2 High Byte Overflow

1

1

Timer 2 Low Byte Overflow

1

----------------------------------------------

=

=

3

----------------------------------------------

=