Справочник Пользователя для Insignia NS-24ED310NA15
69
Insignia 24" LED TV/DVD Combo
www.insigniaproducts.com
8 Highlight Yes, then press ENTER.
If you have plugged in a USB flash drive with the
firmware update, the firmware update starts
automatically. Otherwise, a screen opens with
instructions about how to download the
update. Follow the instructions, then press
ENTER.
firmware update, the firmware update starts
automatically. Otherwise, a screen opens with
instructions about how to download the
update. Follow the instructions, then press
ENTER.
While your TV installs the firmware update, your
TV displays a status screen. Do not turn off
your TV until the update is complete.
TV displays a status screen. Do not turn off
your TV until the update is complete.
9 When the update is complete, unplug the USB
flash drive, then press ENTER. Your TV turns off
then on to complete the update.
then on to complete the update.
10 If the channel list has been deleted and the TV
Setup wizard open, go through the TV SETUP
wizard. For more information, see “
wizard. For more information, see “
” on page
.
Video and audio
Note
• If you see a message that says the
firmware file is incorrect, make sure
that you have downloaded the correct
file for your model.
that you have downloaded the correct
file for your model.
• If you see a message that says the
update failed or the TV screen is blank
and the power LED is blinking red
then blue, turn off your TV, turn it back
on, then run the upgrade again.
and the power LED is blinking red
then blue, turn off your TV, turn it back
on, then run the upgrade again.
Problem
Solution
Picture does not
fill the screen.
There are black
bars around the
picture.
fill the screen.
There are black
bars around the
picture.
• Change the aspect ratio. An
increasing amount of digital TV
and movies are presented in
wide screen (16:9). See the
“Aspect Ratio” option in “
and movies are presented in
wide screen (16:9). See the
“Aspect Ratio” option in “
” on page
.
No picture (screen
is not lit) and no
sound.
is not lit) and no
sound.
• Press
on the TV or the
remote control.
• Make sure that the Audio Only
option is set to Off. See “
” on page
.
• Make sure that the video cables
are connected securely to your
TV.
TV.
• Adjust the contrast and
brightness. See “
” on page
.
• Make sure that the power cord
is plugged in.
• Make sure that the correct
video input source is selected.
See “
See “
” on page
• Try another channel. The station
may be experiencing problems.
• Make sure that the incoming
signal is compatible.
• Make sure that the antenna or
cable TV is connected correctly
and securely. See “
and securely. See “
” on
page
or “
”
on page
.
• Check the closed caption
settings. Some TEXT modes can
block the screen. See “
block the screen. See “
” on page
or “
” on page
.