Справочник Пользователя для SonicWALL 5.8.1

The SonicWALL security appliance includes a DHCP (Dynamic Host Configuration Protocol) 
server to distribute IP addresses, subnet masks, gateway addresses, and DNS server 
addresses to your network clients. The Network > DHCP Server page includes settings for 
configuring the SonicWALL security appliance’s DHCP server.

You can use the SonicWALL security appliance’s DHCP server or use existing DHCP servers 
on your network. If your network uses its own DHCP servers, make sure the Enable DHCP 
Server checkbox is unchecked.

The number of address ranges and IP addresses the SonicWALL DHCP server can assign 
depends on the model, operating system, and licenses of the SonicWALL security appliance. 
The table below shows maximum allowed DHCP leases for SonicWALL security appliances.

This section provides an introduction to DHCP server options feature. This section contains the 
following subsections:

The SonicWALL DHCP server options feature provides support for DHCP options, also known 
as vendor extensions, as defined primarily in RFCs 2131 and 2132. DHCP options allow users 
to specify additional DHCP parameters in the form of predefined, vendor-specific information 
that is stored in the options field of a DHCP message. When the DHCP message is sent to 

NSA 3500, NSA 4500

1,024 leases

NSA 5000, E5500, E6500, E7500

4,096 leases