Справочник Пользователя для SonicWALL 5.8.1

Best practices information is provided in the following sections:

The following are required for a successful SonicPoint deployment:

SonicOS Enhanced requires public Internet access in order for the UTM appliance to 
download and update the SonicPoint firmware images. If the device does not have public 
Internet access, you will need to obtain and download the SonicPoint firmware manually.

One or more SonicWALL SonicPoint or SonicPoint-G wireless access points.

If you are using a PoE switch to power the SonicPoint, it must be an 802.3af-compliant 
Ethernet switches. Vendor-specific switch programming notes can be found towards the 
end of this section for HP, Cisco, Dell, and D-Link. If not, you will need to use the power 
adapter that ships with the SonicPoint, or SonicWALL’s PoE Injector. See:

It is strongly recommended you obtain a support contract for SonicWALL as well as the PoE 
switch; this will allow you to update to new versions if issues are found on the switch side 
or on the SonicWALL side, or when new features are released.

Be sure do conduct a full site survey before installation (see section below).

Check wiring and cable infrastructure to verify that end-to-end runs between SonicPoints 
and the Ethernet switches are CAT5, CAT5e, or CAT6.

Check building codes for install points and work with building’s facilities staff, as some 
desired install points may violate regulations.